[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: kt7-raid
On Saturday 12 January 2002 18:59, [email protected] wrote:
> Something about my setup doesn't like the controller. Here is what
> happens:
>
> The module is installed in the kernel, and if I enable the controller on
> the mother board there are no problems.
>
> If I hook up a device (a WD hard drive) to the contoller, I can't even
> start to load linux. I get the lilo boot prompt, choose linux, and then
> I get the
> Loading Linux...............................
> .s
>
> and it just stops.
>
> At first I though that perhaps the controller was becomeing IDE 1, but I
> relized that this was not the case when I tried using my Libranet 2.0
> disk and durring the partition set up, it saw every drive properly
> (where I expected them to be).
>
> I'm not sure what could be causing this problem. The windows boot up
> also fails (linux is hda1, windows is hda3), so that makes me guess that
> it is a lilo problem, but I don't since it works fine so long as there
> is no hard drive connected to the controller, I can't figure out what it
> is that could be wrong.
>
> jason
>
I'm almost positive that Winduhs likes to be on hda1 unless something's
changed with them. It mostly insists on being installed first, also, as I
recall.
--
The archive is at https://www.libranetlinux.com/archive.html
To unsubscribe, send email to [email protected]
with a subject of UNSUBSCRIBE.