[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: kt7-raid
Actually, the HPT366 is compiled directly into the kernel. Any other
ideas??
jason
On Sat, 12 Jan 2002, rod wrote:
> May have found your problem. In your post you refered to the modules
> being installed. Did you set up support for the controller as modules?
> If so then the modules aren't loaded until the system boots. Without the
> modules the kernel may be getting 'confused' by a device it knows about
> but doesn't know what to do with it.
>
> The only highpoint controller I've had a chance to look at would go
> active on boot and look for attached drives. Perhaps if there are no
> drives attached the controller goes inactive. If there is a drive
> attached then the drive is listed as a device on the pci bus. This is
> all a guess.
>
> Rod
>
> [email protected] wrote:
> >
> > > I'm almost positive that Winduhs likes to be on hda1 unless something's
> > > changed with them. It mostly insists on being installed first, also, as I
> > > recall.
> >
> > yes is does want to be first, but I was able to move it to a different
> > partition once it was installed. This has worked fine for me. The
> > problem occurs when I hook up a new disk to the raid controller (not
> > running in raid mode).
> >
> > jason
> >
> > --
> > The archive is at https://www.libranetlinux.com/archive.html
> > To unsubscribe, send email to [email protected]
> > with a subject of UNSUBSCRIBE.
>
> --
> The archive is at https://www.libranetlinux.com/archive.html
> To unsubscribe, send email to [email protected]
> with a subject of UNSUBSCRIBE.
--
The archive is at https://www.libranetlinux.com/archive.html
To unsubscribe, send email to [email protected]
with a subject of UNSUBSCRIBE.